Panasonic KX-TDA50 - Page 771

If the printer or personal computer automatically feeds lines with a carriage return, select CR
(Carriage Return).
If not, select CR + LF (Line Feed).
Default
CR + LF
Value Range
CR + LF, CR
Maintenance Console Location
13.1 [11-1] Main
Programming Manual References
None
Feature Manual References
16.1.1 SMDR (Station Message Detail Recording)
Communication—Parity Bit
Selects
a parity bit code that indicates what type of parity is used to detect an error in the string of bits composing
a character.
Make an appropriate selection depending on the requirements of the printer or personal computer.
Default
None
Value Range
None, Mark, Space, Even, Odd
Maintenance Console Location
13.1 [11-1] Main
Programming Manual References
None
Feature Manual References
16.1.1 SMDR (Station Message Detail Recording)
Communication—Word Length
Specifies the number of bits in each byte of a character.
When
connecting the Maintenance Console to the PBX using an RS-232C cable, assign the following values
to the Serial Interface (RS-232C) port of the PBX:
Word Length: 8 bit, Parity Bit: None, Stop Bit: 1 bit
Document Version 2010-11 PC Programming Manual 771
13.1 [11-1] Main