SECTION VII
PARTS LISTS
AND SCHEMATIC/ASSEMBLY DRAWINGS
7.1
INTRODUCTION
This section contains the illustrated parts lists, recommended spare parts lists,
interconnect and programming array lists, and schematic/ assembly drawings.
7.2
ILLUSTRATED PARTS BREAKDOWN (IPB)
Figures
7-1
through 7-7, used in conjunction with Tables
7-1
through 7-7, respectively,
provide identification by Pertec part number
of
the mechanical and electrical components
of the
03000 Series Disk Drives. Notations are made when parts do not apply to all model
configurations.
7.3
RECOMMENDED SPARE PARTS
Table
7-8
provides a list
of
the recommended spare parts for the 03000 Series Disk Drives.
The
Customer should always furnish the model number
and
the serial number
of
the disk
drive when ordering parts.
An additional recommended spare parts list containing the part number, description,
current price for component parts, subassembly parts, and special tools is also available.
This list can
be
obtained by providing the unit part number, from the
10
label
on
the disk
drive,
to
the Logistics Section, Pertec Division
of
Pertec Computer Corporation,
9600
Irondale Avenue, Chatsworth,
CA
91311.
7.4 PART NUMBER CROSS REFERENCE LIST
Table
7-9
provides a cross reference from Pertec component series part numbers to the
basic part identification.
7.5 INTEGRATED CIRCUIT PIN SUMMARY
A summary
of
the power and ground pins for the various integrated Circuits employed in
the
03000 Series Disk Drives is contained in Table 7-10. A summary
of
the function control
for certain integrated circuits is
listed in Table 7-11.
7.6
PCBA INTERCONNECTIONS
Interconnections between PCBAs installed in the 03000 Series Disk Drives are listed in
Table
7-12
and illustrated in Figure 7-8*.
*Foldout drawing,
see
end
of
this Section.
7-1
8300
To Next Page
Loading...