Pentax R-200 Series - Page 136

71
Press [ENT] to open the input window of PN, X, Y, Z and IH value.
Input each Character or value and press the ENT key to view the STATION POINT H. ANGLE SETUP
screen.
Input the H. angle by pressing [F2][INPUT], [F3][0SET] and [F4] [HOLD] or Backsight Coordinates by
pressing [F5][BSP].
Press [ENT] to open the input window when using [F5][BSP].
Pressing [F2][INPUT] Pressing [F5][BSP]
Aim at the reference point, and press [ENT] to view the MEASURE screen.
Aim at point 1 and press [F1][ MEAS ] . Measured Coordinates are displayed.
Press [ENT] to view the same MEASURE screen.
In the same manner, aim at point 2 and press [F1][ MEAS ]. Measured Coordinates are displayed.
２