Filling The Moistener Tank
Refer to the following procedure to refill the moistener.
1. Check the moistener tank to see how much sealing solution is left.
2. Add enough E-Z Seal® to bring the sealant level up to the bottom of the fill hole. We recommend
E-Z Seal because it helps keep your moistener clean and improves sealing efficiency. Refer to the
Pitney Bowes Contact List to order E-Z Seal.
3. If the tank was empty, allow 30 minutes for the moistener brush and wick to get completely wet.
NOTE: Do not overfill the moistener tank.
Maintenance
Pitney Bowes Operator Guide February, 2017 Page 60 of 226
To Next Page
Loading...
