Pitney Bowes Epic - Page 108

4. Continuetomakefineadjustmentstobothendsofthechassissideguide-bothdownnearthe
observationguideandontheupstreamsectionofthechassisguide-untilitissetproperly.
5. Confirmonelasttimedownbytheobservationguidethattheguidesmeetwiththeproper
alignment.
6. Placethewidestdocumentinthejobbetweentheguidesandcenterit,leavingabout1/8-inch
(3.1mm)oneachside.
7. Dothisforanyadditionalupstreamchassissections,maintainingthe1/8-inch(3.1mm)gapon
eithersideofthematerial.
8. Closethefeedercovers.
Operator Adjustments
Pitney Bowes Epic Select Operator Guide December,2017 Page 102 of 288