Pitney Bowes Epic - Setting up the Entrance to the on Edge Stacker

Setting Up the Entrance to the On Edge Stacker
TohelpmakesuretheOnEdgeStacker(OES)stacksmailproperly,usethesesetupguidelines.
1. Forproperstackingheighttheenvelopemustbesetto1/2-inch(12.7mm)offthedeck.
Item Description
1 1/2-inch(12.7mm)OffsetfromDeck
2 PaperFlowandStackerExit
EnvelopesSetto1/2-inch(12.7mm)OfftheDeck(shown here in closeup)
2. Toadjusttheheight,movetheactuatorswitchupordown.
3. Aftersettingtheproperheight,adjusttheentranceguidestokeepthesameheightconsistent.
Operator Adjustments
Pitney Bowes Epic Select Operator Guide December,2017 Page 86 of 288