Pitney Bowes Epic - Adjusting the Friction Feeder Separator

Adjusting the Friction Feeder Separator
Eachfrictionfeederhasaseparatorthatseparatesthematerialduringthefeedcycle.Theseparators
canbeadjustedtoaccommodatevariousinsertthickness.Theadjustmentoutlinedheregetsthesetup
veryclosetothefinalsetting,butyoumayhavetocontinuemakingadjustmentsatthestartofthejob.
Note:
Thebeltsshowninthesephotosareblue,butfeederbeltscanalsobered,tanorblackdependingonthesystem
configurationandthematerialbeingprocessed.
1. Loosenthefeedersideguidelockingknobs.
2. Turnthesideguideadjustmentknobclockwiseuntilitstops(side guides all the way open).
Item Description
1 LockingKnobs
2 SideGuideAdjustmentKnob
3 SeparatorKnob
FeederSideGuideControlKnobs
Operator Adjustments
Pitney Bowes Epic Select Operator Guide December,2017 Page 115 of 288