Pitney Bowes Epic - Operator Adjustments

Operator Adjustments
Thereareseveraladjustments(bothmechanicalandthroughthesoftwareGUI)operatorscanmake
duringjobsetup,runningajobandtroubleshootingactivities.Theseadjustmentsaregroupedbyareasof
thesystemtomakeiteasiertofindtheprocedures.
l EnvelopeFeeder
l Engine
l Sealer
l VerticalStacker
l OnEdgeStacker(OES)
l Chassis
l FrictionFeeders(insertfeeder)
l RotaryFeeders(insertfeeder)
l Buffer
Note:
Afterloadingamode,homethechassisbypressingtheStartbuttononce.
Job Changeovers
Changeoveradjustmentsmayberequiredifthenewjobyouareabouttorunhasmaterialthatisa
differentorientation(portraitorlandscape),sizeormaterialthicknessthanthepreviousjob.
Someoftheadjustmentsforajobchangeoverthesystemmakesautomatically,andsomeyouneedto
makemanually.Refertothe"JobChangeoverGuidelines"topicfordetailedinformation.
Operator Adjustments
Pitney Bowes Epic Select Operator Guide December,2017 Page 51 of 288