Pitney Bowes Epic - Envelope Specifications

Envelope Specifications
Envelopeswhosecharacteristicsfalloutsideoftheseconstructionguidelinesmustbeevaluatedby
testingofcustomersamples.
Primary Envelope Requirements
TheEpicSelectInsertersystemcanprocessthefollowingtypesofenvelopes:
l Executiveenvelopes(to achieve maximum productivity, truncated flap is recommended)
l Diagonalcutenvelopes
l Sideseamenvelopes
EnvelopeGuidelines
l Allseamsshouldbesecurelybondedtothebottomflapwithoutexhibitinganycurlorripple
betweentheflaps.
l Envelopecurlortwistshouldnotexceed.25"(6.4mm)whentheenvelopeisplacedonaflat
surface.
l Theenvelopethroatshouldbeamaximumof.25"(6.4mm)belowthecreaselineat.75"(19mm)
fromthesideedges.
EnvelopeMeasurements Minimum MaximumFolded
Width* 7"(178mm) 11.50"(292mm)
Length** 3.88"(98mm) 6.38"(162mm)
Weight 20lbbond(75gsm) 28lbbond(105gsm)
EndClearance SeeEnd ClearanceandHorns 1.25"(32mm)
BottomofFlaptocreaseline 1.25"(32mm) 1.75"(44mm)standard
2.50"(64mm)custom
*Widthisdefinedasthedimensionparalleltotheaddressdirection
**Lengthisdefinedasthedimensionperpendiculartotheaddressdirection
Specifications
Pitney Bowes Epic Select Operator Guide December,2017 Page 251 of 288