Pitney Bowes Epic - Setting up the Vertical Stacker

Setting Up the Vertical Stacker
Theverticalstackerisprimarilyusedtotransportmaterial.Itcanalsobeusedasadiverter,dependingon
theapplication.
This adjustment is only performed when stacker material is changed or possibly after a service call.
1. Usetheoperatorsetuptooltoloosenthescrewthatholdsthewheeltothebrackettoadjustthe
directionoftraveloftheenvelope.
VerticalStacker-ScrewsonWheels
2. Angletherollermoretotherighttodirecttheenvelopetowardthebackwalloftheverticalstacker.
(Sliding the roller to the left will steer the envelope away from the back wall.)
3. Tightentherollers.
Note:
Rollersareusedtocorrectsmallamountsofskewormisalignmentonly;adjustmentsshouldbeslight.
Alwayscheckupstreamofwheretheskew/misalignmentoccurredtoseeifanotherareaistheissue.
Error Recovery
Pitney Bowes Epic Select Operator Guide December,2017 Page 212 of 288