Pitney Bowes Epic - Disabling (and Enabling) the Inserter

Disabling (and Enabling) the Inserter
WhenyouareloggedinasanOperator,youcandisabletheinserterfromanyrunactivity.Typically,you
mightonlydisablethesystemifdirectedbyService.
Forexample,ifServiceneedstoperformdiagnosticactivityonthemachine,theymayaskyoutodisable
thesystem,toavoidhavingtocompletelyshutdown.Thisfreezessystemactivity,preservingdatathat
maybehelpfulfordiagnosingissues.
Whenyouarereadytostartrunningthejobagain,youcanenablethesystem.
1. ClicktheMenubuttononthebottomofthemainDCscreen,neartheStartbaratthebottomofthe
screen.
2. SelectDisableSystem.Theinserterstopsandcannotbestarteduntilit'senabledthroughDC.
3. Whenyouarereadytoruntheinserter,clicktheMenubuttonandselectEnableSystem.The
inserterisenabletostartwhenyouareready.
Using Direct Connect
Pitney Bowes Epic Select Operator Guide December,2017 Page 44 of 288