Pitney Bowes Epic - Page 229

Sealer
Issue Cause Resolution
Highseals Constantbadfolds Adjustfold,refertoassociatedFolderOperator
Guide
 Incorrectbackwallsetting Enginesetup
 Tonguelocation Adjust tongue
 Suctioncupplacement Adjust suction cup
 Hornwidth Increase horn spacing
 Observationguidealignment Check observation side guide setup
  
FlapnotSealed Incorrectbackwallsetting Enginesetup
 Notenoughfluidappliedtoflap Adjustsealerfluid
On Edge Stacker (OES)
Issue Cause Resolution
Jam Highseals InspectforhighsealsandrefertoSealer
 Beltadjustment/envelopepositioning Adjust the OES entrance setup
 Stackingtootightonbelt Increasespeedofconveyorbelt
Troubleshooting
Pitney Bowes Epic Select Operator Guide December,2017 Page 223 of 288