Pitney Bowes Epic - Page 270

Enclosure Specifications
Measurements Minimum Maximum
Length 3.0"(76mm) .6.25"(159mm)
Width 5.5"(140mm) 10.0"(254mm)
TotalEnclosureThickness-
MaxSpeed
.0038"(0.1mm) .125"(3mm)
l Enclosuredimensionsshouldnotvarymorethan+/-.03125"(1mm).
l Enclosurecurlortwistshouldnotexceed.125”(3mm)whenenclosureisplacedonaflatsurface.
l ContactPBEngineeringifanapplicationfallsoutsidethespecifications.
Folded Enclosure Specifications
l Foldsthatresultinanevenoverallthicknessofenclosurewillgivethebestfeedingperformance.
l Foldsthataremadeparalleltothepapergraindirectionarepreferred.Thisresultsinacleaner,
straighterfoldwithlessthicknessincreaseatthefold.
l Foldsshouldbesharplycreased,flat,andfreeofedgecurl(see diagram).
CurlatFold
l Foldsmustnotresultinthefreeendsbeinggreaterthan.25"(6mm)fromafold (see diagram).
FreeEndsat1/4"(6mm)Maximum
Specifications
Pitney Bowes Epic Select Operator Guide December,2017 Page 264 of 288