7-8 SV63136 Rev. A
7 • Add-On Modules
Flats Sealer
The Flats Sealer add-on module attaches to the exit end of the base module
to allow for the sealing of flat envelopes. The Flats Sealer can seal flat enve-
lopes up to 0.25" (6.5 mm) in thickness.
In the Moistener, Closer, Sealer module, brushes sweep across the flat
envelope flap to wet the glued area of the flap. The Flats Sealer closes the
flap, seals the envelope, and sends it on to the next module downstream.
While the Flats Sealer is designed specifically to seal flat envelopes, it has
an exit path for (sealed) letter envelopes exiting the Moistener, Sealer, Clos-
er module.
Flats Sealer Downstream Attachments
Letter Exit Path • Drop Stacker (Letter Mail)
• Vertical Power Stacker
• Belt Stacker
• Exit Transport/Mail Machine Interface/Mailing Machine
Flats Exit Path • Drop Stacker (Flat Mail)
• Belt Stacker
• Exit Transport
Figure 7.8: Flats Sealer Module (shown here with an HCEF)
Flast SealerCover
To Next Page
Loading...
