Pitney Bowes Relay 5000 - Feeder Trays; Sheet Trays

2-6 SV63136 Rev. A
2 • Meet the Inserting System
There are two types of feeder trays:
• Sheet Trays
• Insert Trays
Required tray type is based on the type of material selected for a given job.
Feeder Trays
Sheet Trays
Sheet trays feed flat, unfolded material. Use only the recommended
materials. Refer to the specifications in this guide.
NOTE: Sheet trays have ll marks on their side walls. Be sure to keep your stack
of materials at or below these marks to avoid feed problems.
Figure 2.3.1: Sheet Trays