7-14 SV63136 Rev. A
7 • Add-On Modules
Belt Stacker - Letter or Flats Mail
The Horizontal Belt Stacker can be used in Right Angled or In Line configu-
ration with the
Relay inserters.
There are two setups for In Line operation: One for letters (e.g. #10 / DL/C5)
sized envelopes, and another for ‘flats’ (e.g. #9 / C4) sized envelopes. In
Line mode is essential for running flats.
Tandem Belt Stacker - Letter and Flats Mail
A particular configuration of the stacker is available for the Relay inserters
that allows automatic stacking of ‘Letters’ and ‘Flats’ simultaneously. The
stacker consists of two stacker units mounted onto one set of legs or one
table at the correct vertical spacing to receive ‘Letter’ and ‘Flats’ output from
the Inserter.
Refer to the Horizontal Belt Stacker Operator Guide (SV40231) for detailed
information about the belt stacker and the tandem belt stacker.
Horizontal Belt
Stacker
Vertical Power
Stacker
The Vertical Power Stacker is a compact, powered, bottom-feed stacker
that connects to the output of several Pitney Bowes Document Inserting
Systems, including the Relay inserters. It neatly stacks the mail pieces fed
from the inserter and keeps them in the same order as they were originally
loaded. Sensors in the stacker monitor the mail pieces fed into it; if a mail
piece should stall or the stacker fills up, the inserter stops automatically.
The stacker is designed for continuous unloading during mail runs to
maintain best productivity. Unloading "on-the-fly" keeps your mail run going
and helps avoid unnecessary interruptions.
Refer to the Vertical Power Stacker Operator Guide (SV61322) for detailed
information about the vertical power stacker.
Exit Transport
The Exit Transport assembly extends the path of the letter envelope exit
beyond the distance needed for flats stacking below. The Exit Transport
connects to the inserter and can be mounted to other output devices while
maintaining flats envelope functionality.
The Exit Transport also provides optimum operator access to the High
Capacity Envelope Feeder (HCEF) in certain configurations.
To Next Page
Loading...
