SV63136 Rev. A
2-21
Meet the Inserting System • 2
There are two security modes available on the system:
• Login Not Required Mode - requires four-digit access code to perform
supervisor and manager functions.
• Login Required Mode - sets up access levels and requires a user
ID and password for all system operator, supervisor, and manager
functions.
The system has three levels of user access, and one level for service
personnel. The three user access levels are:
• Operator
• Supervisor
• Manager
Depending upon the security mode, the supervisor and manager access
levels requires entry of an access code or user ID and password. These are
assigned by the system manager.
Operators have access to any of the function not listed as supervisor or
manager functions. System operators may be required to log in and out of
the system, if a security mode has been enabled.
Chapter 3 describes the steps involved with performing each of the non-
restricted procedures.
Supervisors have access to all operator functions and the following after
logging in with the correct access code or user ID and password:
• Saving a Job
• Deleting a Job
• Creating Accounts
• Deleting Accounts
Chapter 4 describes the steps involved with performing these supervisor-
level functions.
Managers have access rights to all of the above functions plus exclusive
rights to manage other users, i.e., assign/restrict functions and selecting the
Account Mode.
Chapter 4 explains the process for assigning user IDs and passwords and
selecting the Account Mode.
Access Rights
To Next Page
Loading...
