3-28 SV63136 Rev. A
3 • Basic Operation
Creating a Job
(continued)
• If the new job does not require scanning, select Normal Type to
continue.
• If the new job requires scanning, select Scanning Job.
4. The Create Outer Envelope screen displays.
• If the job does not require an outer envelope, select No.
• If the job requires an outer envelope, select Yes.
- Select the appropriate outer envelope options for the job. Refer
to the Envelope Options table in this chapter for more information
about each of the related menu options.
- Press Accept when done.
- If the job is a scanning job, the Create - Only One Envelope
screen displays. If the job requires only one envelope, select Yes
and proceed to step #5.
If the job requires an additional envelope, select No, Two Outer
Envelopes. Validate the available options, and press Accept
when done.
NOTE: If this is a scanning job, and you will be using dynamic
envelope selection, you must select “No, Two Outer Envelopes”.
5. The Create - Select Next Item screen displays. Select the appropriate
option.
Menu Options Associated Options/Actions
Reply Card
Reply Envelope
Pre-Folded Insert
Small Booklet
Slip
Generic Insert
Large Booklet
Stiff*
a. If this is a scanning job, follow the steps below. Otherwise, go
to step b.
• The Scan Type screen displays. Select the appropriate
Scan Type (OMR, Code 3 of 9, or Interleaved 2 of 5.)
• The Scan Configuration screen displays. Select the
appropriate Scan Configuration.
• The Content - In Line with Marks screen displays. If there
is content in line with the scan marks, select Yes. If there
is no content in line with the scan marks, select No
b. Select the appropriate options for the insert. Press Accept”
when done.
Refer to the Insert Options table in this chapter for specific
information about each of the related menu options.
*The Relay 8000 is required for this item.
To Next Page
Loading...
