3-30 SV63136 Rev. A
3 • Basic Operation
Creating a Job
(continued)
Menu Options Associated Options/Actions
Job Comments Use the alphanumeric matrix to enter any additional information
related to the job. If the job will be saved by a supervisor or
manager, you can make it easy for operators to identify/select the
correct job in the future by entering a job description in the job
comments area.
NOTE: Job comments can contain up to 120 characters.
Batch Mode Toggle:
• Off means this feature will not function for this job, or
• On means this feature is active.
NOTE: Batch mode cannot be used with scanning jobs.
Batch Count Use the numeric matrix to enter the batch count value.
NOTE: The batch count can contain up to four digits. The
minimum is "5" and the maximum is "9999".
Set Over Max Count Indicates what will happen to sets that exceed the set over count
quantity. Choices include Divert and Stop.
Use Postage Meter Select this option if you will be using the Mail Machine Interface
(MMI). This interface enables communication between the Inserting
System and a Connect+ mailing system via a USB connection.
The system sends start and stop signals to the mailing system, and
the mailing system can send error messages back to the inserter to
stop feeding.
Toggle:
• Off means this feature will not function for this job, or
• On means this feature is active.
NOTE: The MMI is a purchasable exit option. Only letter-sized
envelopes can be used with this interface.
Refer to “Connect+ MMI” in Chapter 7 for more information about
the MMI.
Advanced Allows access to advanced job settings.
IMPORTANT: Do not change the advanced job settings unless
instructed to do so. Changing settings may affect inserter
performance.
Mark Piece Count Select this option if you have a Flats Sealer and want to use
the envelope edge marker to mark every nth envelope. Use the
numeric matrix to enter the appropriate value.
NOTE: The Flats Sealer is a purchasable exit option. Only
letter-sized envelopes can be marked using the envelope
edge marker. Refer to Chapter 7 for more information about
the Flats Sealer.
8. Select Accept when done.
9. The Create - Saved Created Job screen displays.
• Select Yes, Save to save the job (optional). You must have
supervisor or manager access rights to save jobs.
• Select No, Save Later if you do not have supervisor or manager
access rights.
To Next Page
Loading...
