Setup & User Guide
65 |
DOC-246-GDE-Pivot3 Acuity 2.3 Setup & User Guide-v1.0.docx
NOTE: The IP Addresses for NIC 0 must all be on the subnet defined by Subnet 0; the IP Addresses for NIC 1 must all be on the
subnet defined by Subnet 1.
Once all IP addresses have been entered or discovered, click Finish.
Verify Administrator credentials (user name and password) if applicable. The vPG creation process will begin. This
may take several minutes to complete; the time to completion varies depending on the number of nodes.
To Next Page
Loading...