To Next Page

To Previous Page

11.21

9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual

LIGHTING SYSTEM

Headlight Adjustment

The headlight beams are adjustable.

1. Place the vehicle on a level surface with the

headlight approximately 25 ft. (7.6 m) from a wall.

2. Measure the distance from the floor to the center of

the headlight and make a mark on the wall at the

same height.

3. With the machine in Park, start the engine and turn

the headlight switch to the LOW position.

4. The most intense part of the LOW beam headlight

beam should be aimed 2 in. (5 cm) below the mark

placed on the wall in Step 2.

NOTE: Rider weight must be included in the seat

while performing this procedure.

5. Adjust the beam to the desired position by loosening

or tightening the three T-25 adjustment screws and

moving the lamp to the appropriate height.

6. Adjust the beam to desired position. Repeat the

procedure to adjust the other headlight.

WARNING

Due to the nature of light utility vehicles and where they

are operated, headlight lenses become dirty. Frequent

washing is necessary to maintain lighting quality. Riding

with poor lighting can result in severe injury or death.

ELECTRICAL

Polaris RZR XP 1000 Service Manual

Other manuals for Polaris RZR XP 1000