Polaris RZR XP 1000 Service Manual

7
7.9
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
© Copyright 2014 Polaris Industries Inc.
Rear Bearing Carrier Installation
1. Install drive shaft through the backside of the bearing
carrier.
2. Install the four fasteners
1
that attach the rear
bearing carrier to the trailing arm. Install the one
fastener
2
that attaches the upper radius rod to the
bearing carrier. Torque bolts to specification.
NOTE: Use new nuts upon installation of the
rear bearing carrier.
Bearing Carrier to Trailing Arm Bolts:
42 ft-lb (54 Nm)
Radius Rod to Bearing Carrier Fasteners:
40 ft-lb (54 Nm)
3. Apply anti-seize to drive shaft splines.
4. Install rear wheel hub assembly
2
, cone washers
3
,
and hand tighten the castle nut. Install washers with
domed side out.
5. Install the rear brake caliper assembly and new bolts
4
. Torque to specification.
Rear Caliper Mounting Bolts:
40 ft-lbs (54 Nm)
FINAL DRIVE

Polaris RZR XP 1000 Specifications

General

Brand	Polaris
Model	RZR XP 1000
Category	Offroad Vehicle
Language	English