Polycom CX5500

Polycom CX5500 Unified Conference Station Administrator’s Guide 1.1.0
Polycom, Inc. 247
Parameter
Permitted Values
Default
device.logincred.password
1
string
Null
The CMA account password. Note: If you will modify this parameter, the phone will re-provision. The phone may
also reboot if the configuration on the CMA server has changed.
device.logincred.user
1
string
Null
The CMA account user name. Note: If you will modify this parameter, the phone will re-provision. The phone may
also reboot if the configuration on the CMA server has changed.
device.net.cdpEnabled
1
0 or 1
Null
If set to 1, the phone will attempt to determine its VLAN ID and negotiate power through CDP.
device.net.dot1x.anonid
1
string
Null
EAP-TTLS and EAP-FAST only. The anonymous identity (user name) for 802.1X authentication.
device.net.dot1x.eapFastInBandProv
1
0 or 1
Null
EAP-FAST only, optional. Choose 1 to enable EAP In-Band Provisioning by server unauthenticated PAC
provisioning using anonymous Diffie-Hellman key exchange. Choose 0 to disable EAP In-Band Provisioning.
Reserved for Future Use—Choose 2 to enable EAP In-band provisioning by server authenticated PAC
provisioning using certificate based server authentication.
device.net.dot1x.enabled
1
0 or 1
Null
If 0, 802.1X authentication is disabled. If 1, 802.1X authentication is enabled.
device.net.dot1x.identity
1
string
Null
The identity (user name) for 802.1X authentication.
device.net.dot1x.method
EAP-None, EAP-TLS,
EAP-PEAPv0-
MSCHAPv2, EAP-
PEAPv0-GTC,
EAP-TTLS-MSCHAPv2,
EAP-TTLS-GTC, EAP-
FAST, EAP-MD5
Null
Specify the 802.1X authentication method, where EAP-NONE means no authentication.
device.net.dot1x.password
1
string
Null
The password for 802.1X authentication. This parameter is required for all methods except EAP-TLS.
device.net.ether1000BTClockLAN
1
Auto, Slave, Master
Null
The mode of the LAN clock. Polycom recommends that you do not change this value unless you have Ethernet
connectivity issues.
device.net.ether1000BTClockPC
1
Auto, Slave, Master
Null
The mode of the PC clock. Polycom recommends that you do not change this value unless you have Ethernet
connectivity issues.