Polyend Tracker Mini - FX Steps; Overdrive; Low Pass Cutoff

119
Polyend Tracker Mini Manual
118
Polyend Tracker Mini Manual
NOTESNOTES
1-Shot Parameters
The available parameters are simple for the 1-shot option with only two
editing parameters and one visual aid. Navigate and select using the
Screen Buttons. Also navigate using the (Left) (Right) buttons to select the
parameter and (Up) (Down) or [+] / [-] to adjust the value.
Zero Crossing option can be set in the Cong > Project settings.
Instruments
6
Instruments
6
6.7 1-Shot Play Mode
The most basic play mode is 1-shot which simply plays a sample through
once, start to end. This is the normal operation when using samples without
too audio much editing and where the general duration of the sample is to
be retained.
The note value, tempo and pattern length will also affect how the sample
plays. A higher note value will play the sample faster. A lower note value will
play the sample slower. Triggering the instrument step will trigger the 1-shot
sample which will play for its duration or until another trigger is initiated.
Steps
Time
1-Shot
Sample
1-Shot
Sample
G5
Original
G6
Faster
G4
Slower
Step Note Trigger
Sample plays once, when triggered. Note value affects pitch. Sample will play
until complete or until another trigger is activated in which case it is restarted.
Higher note values will shorten i.e. speed up the sample while lower values will
elongate i.e. slow the sample. The sample and pattern length should be
considered as well as tempo to achieve desired results. Sample tempo and pitch
are not automatically analysed in Tracker Mini and therefore not normally known
unless manually noted when sampling and recording the original audio.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Start EndZoom
1-Shot
Preview
0.000s
Start
0.000s
Zoom
1.00
End
6.000s
Play Mode
Sample Playback 0m:00s P3.002
1-Shot
Slice
Forward loop
Beat Slice
Backward loop
Wavetable
Pingpong loop
Granular
16.hh3
Function Parameter
Screen
Button
Range Description
Edit Play Mode 7th & 8th
Modes
Selects the play mode to apply. Includes 1-Shot
plus loop modes and wavetable / granular synth.
Aid Zoom 6th
Variable
Zooms in horizontally to the visual display for more
precise editing. Does not affect playback. Zoom
reference point is based on the previously adjusted
parameter i.e. Start.
Aid Preview 1st
Variable
Hold to play the sample. The number below the
screen button label indicates current play position
in seconds. Preview playback will run for approx 1
sec after releasing the preview button.
Edit Start 2nd
Variable
Adjusts and edits the sample start point. This is the
starting position used when a 1-shot sample is
triggered in a pattern or when previewed. Marker is
red but will change to green if a zero crossing point
is detected at the current position.
Edit End 5th
Variable
Adjusts and edits the sample end point. This is the
ending position used when a 1-shot sample is
triggered in a pattern or when previewed. Marker is
red but will change to green if a zero crossing point
is detected at the current position.