NOTICE!
To avoid unexpected disconnections, it is neces-
sary to fix the cable on both sides as well on the
control unit, as on the first PAMIO box.
For the fixation of the Superbus cable, the screws
that fix the 50 pin Sub-D input connector of the first
PAMIO box must be replaced by studs! These
studs are delivered with the PAMIO backplane.
Fig. 21: PAMIO system with two racks
NOTICE!
In case of interconnection between racks, the
screws that fix the 50 pin Sub-D output connector
of the last PAMIO box in the first rack and those of
the input connector of the first PAMIO box in the
following rack must be replaced by studs! These
studs are delivered with the PAMIO backplane.
Cable Fixation
PAMIO Systems With Several
Racks
PA 8000 PAMIO
PAMIO Components
12.01.2017 | 43
To Next Page
Loading...