NOTE: The USB Flash drive must be 2GB or smaller for the PowerMaster
®
to recognize the
device.
The following steps show the user how to update the PowerMaster
®
in the field:
STEP 1
Insert USB Flash drive into a
USB peripheral and press F3
to scan. Verify unit is plugged
into AC Power.
STEP 2
Select the .PMX upgrade file
and press F6 to install
STEP 3
After recognition, reset the
PowerMaster
®
by turning off
then turning back on
STEP 4
After power up, the
PowerMaster
®
will run the
update application
automatically (this may take
several minutes)
STEP 5
After installation, reset the
PowerMaster
®
by turning off
then turning back on
Rev 1.5 125
To Next Page
Loading...