14.5 Safety
Before energizing or performing any test, verify all safety precautions have been met. The below
procedures are not intended to be a final checklist, nor is it to take place of any internal safety
procedures.
1. Verify the 335 is connected to the 3 series with current cables, communication cable and
battery cable all safely and correctly connected.
2. Verify the duckbills are inserted and tightened in the correct jacks on the 335.
3. Verify the voltage cable is connected to the 3 series.
4. Verify the 335 is turned on via the LED shown below:
5. Verify the 3 series is turned on.
Rev 1.5 150
To Next Page
Loading...
Need help?
General