What is “Kt”?
The value Kt is the test pulse register. In most situations, the Kh value on the meter nameplate is
the same as Kt.
What does “Enabled” mean?
“Enabled” means that the component will always show in the Editor drop down box. Most utilities
have a few manufacturers in their entire system. Since this is true, the user may not want to view
ALL components that the PowerMaster
®
holds in the database. This is especially true if the utility
has one or two components they presently use. When you “disable” a component, it will not show
in the Editor’s drop down box. In short, if the user uses a component (Meter, CT, PT, or AMR)
that is in the database, make sure it is “enabled.” All others should be “disabled.”
Rev 1.5 54
To Next Page
Loading...