PowerMeasuringModule PMM
35,0(6
75
Revision 13 EN - 02/2023
After the confirmation of all entries, the module is created and appears in the list of Ethernet devices (see Fig.
13.11 on page75).
Fig. 13.11: Device list in the directory tree
As far as the controller tags are concerned, the PMM now has an entry in its I/O range. These data have the
format Array of SINT, which means that a conversion of the data into the structural variables of the PMM has
to be done (same procedure as for DeviceNet™). As soon as the control is in RUN Mode, the variables are
constantly updated.
Fig. 13.12: RUN-Mode
To Next Page
Loading...
