Pulsar ULTRA 5 - Page 30

Page 22
The temperature sensor should be placed close to the point of measurement.
The unit is connected as follows:
Description
Temperature
Sensor
Ultra 5 Wall
mount
Ultra 5
Rack & Panel
Ultra 5 Fascia
Mount
Power Supply
Terminal 1
Terminal 27
Terminal a12
Terminal 25
Return
Terminal 2
Terminal 28
Terminal a14
Terminal 24
Temp Source (P852), should be set to option 4 or 5 depending on the sensor
range, set 4 for type A and 5 for type B (see above), the range is specified on the
label of the sensor.
RS232 Serial Interface
If required, you can connect to the serial interface, to operate your Ultra 5
remotely.