quadient iX-5 User Manual

4. Lift the metal retainer to remove the sponge.
Remember its direction.
5. Clean the sponge and the brush.
6. Re-install the sponge and retainer.
7. Put the brush back and push the release lever back down until it snaps into place.
8. Push down on the upper drive assembly until it locks back into position.
The Weighing Device does not Weigh Properly
If the Base does not display a correct weight, complete the following actions to correct
the problem.
Display _g indicates a weighing error. When this weighing error
occurs on the home screen, the Standard Weighing type is
automatically selected if the Automatic Weight Detection is
activated, see How to Activate the Automatic Weight Detection
on the WP on page 221.
You have to check the weighing device as follows.
ActionsPossible causes
See the weighing type selection
procedures in Choosing a Weighing Type
on page 73.
The weighing device is not selected.
304
| Page 304 | Jun-21-2021 12:11 |
13
Troubleshooting

quadient iX-5 Specifications

General

Connectivity	Ethernet, USB
Print Technology	Inkjet
Processing Speed	Up to 15, 000 letters per hour
Weighing Platform	Integrated weighing platform
Envelope Feeding	Automatic envelope feeding
Display	Touchscreen display
Technology	Inkjet
Speed	Up to 15, 000 letters per hour
Maximum Print Width	2"
Media Types	Envelopes, labels