How to Tare the Weighing Platform in Supervisor Mode
To Tare the Weighing Platform in Supervisor Mode:
1. Log in as the Supervisor (see How to Log in as the Supervisor on page 114), then:
Press and type 6.1
Or
Select the path: System Settings Weigh Platform Tare
2. Press [OK] to Tare the Weighing Platform.
GEO Code
Your Weighing Platform calculates mail piece weights that have to be corrected according
to the geographical location of your Mailing System because weights can change with the
altitude and latitude.
The Geodesic Code used to adjust the weight value may be entered into your system:
•
Automatically with E-Services
•
Manually in Supervisor Mode.
How to Change the GEO Code
To change the GEO code manually, follow the instructions outlined below.
Changing the GEO code modifies the weight values the Mailing
System calculates. Make sure you enter the correct GEO Code to
ensure your weights are accurate.
To change the GEO code:
1. Log in as the Supervisor (see How to Log in as the Supervisor on page 114 ):
Press and type 6.2
Or
Select the path: System Settings GEO Code
9
Configuring your Mailing System
127
| Page 127 | |
To Next Page
Loading...
Need help?
General
