QUANTA STRATOS S210 Series S210-X12RS - Page 209

CHAPTER TITLE WEB GRAPHICAL USER INTERFACE (GUI) FOR ESMS
4-36
 Choose the particular channel number that event mes-
sage was received over. Or choose '0' if the event mes-
sage was received via the system interface, primary
IPMB, or internally generated by the BMC.
 Choose the corresponding IPMB device LUN if event
generated by IPMB.
6. In the Sensor configuration section,
 Select the s type of sensor that will trigger the event fil-
ter action.
 In the sensor name field, choose the particular sensor
from the sensor list.
 Choose event option to be either All Events or Sensor
Specific Events.
7. In the Event Data configuration section,
 Event Trigger field is used to give Event/Reading type
value.
 Event Data 1 AND Mask field is used to indicate wild-
carded or compared bits.
 Event Data 1 Compare 1 & Event Data 1 Compare 2
field is used to indicate whether each bit position's com-
parison is an exact comparison or not.
8. In the Event Data 2 configuration section,
 Event Data 2 AND Mask field is similar to Event Data 1
AND Mask.
 Event Data 2 Compare 1 & Event Data 2 Compare 2
fields are similar to Event Data 1 Compare 1 and Event
Data 1 Compare 2 respectively.
9. In the Event Data 3 configuration section,
 Event Data 3 AND Mask field is similar to Event Data 1
AND Mask.
 Event Data 3 Compare 1 & Event Data 3 Compare 2
fields are similar to Event Data 1 Compare 1 and Event
Data 1 Compare 2 respectively.
10.Click Modify to accept the modification and return to
Event filter list.
11.Click Reset to reset the modification done.
12.Click on Cancel to cancel the modification and return to
Event filter list.
13.In the Event filter list, click Modify to modify the existing
filter.
Note:
Value ranges from 1 to 255.
Note:
Value ranges from 0 to 255.
Note:
Value ranges from 0 to 255.