QUANTA STRATOS S210 Series S210-X12RS - Page 210

CHAPTER TITLE WEB GRAPHICAL USER INTERFACE (GUI) FOR ESMS
4-37
14.In the Event filter list, click Delete to delete the existing fil-
ter.
Alert Policy Tab
This page is used to configure the Alert Policy and LAN destina-
tion. You can add, delete or modify an entry in this page.
Figure 4-26. PEF Management – Alert Policy
The fields of the PEF Management – Alert Policy Tab are
explained below.
Table 4-25: PEF Management - Alert Policy
I
TEM DESCRIPTION
Policy Entry #
Displays Policy entry number for the newly
configured entry (read-only).
Policy Number Displays the Policy number of the configuration.
Policy Configuration To enable or disable the policy settings.
Policy Set
To choose any one of the Policy set values from
the list.
 0: Always send alert to this destination.
 1: If alert to previous destination was suc-
cessful, do not send alert to this destination.
Proceed to ESMS Functional Specification
For SI v0.11 next entry in this policy set.
 2: If alert to previous destination was suc-
cessful, do not send alert to this destination.
Do not process any more entries in this policy
set.
 3: If alert to previous destination was suc-
cessful, do not send alert to this destination.
Proceed to next entry in this policy set that is
to a different channel.
 4: If alert to previous destination was suc-
cessful, do not send alert to this destination.
Proceed to next entry in this policy set that is
to a different destination type.
Channel Number
To choose a particular channel from the
available channel list.
Destination Selector
To choose a particular destination from the
configured destination list.
Note:
LAN Destination has to be configured - under
Configuration > PEF > LAN Destina-
tion.
Table 4-25: PEF Management - Alert Policy (Continued)
I
TEM DESCRIPTION