QUANTA STRATOS S210 Series S210-X12RS - Page 226

CHAPTER TITLE WEB GRAPHICAL USER INTERFACE (GUI) FOR ESMS
4-53
4. Enable or Disable the User Access Privilege.
5. In the Network Privilege field, enter the network privilege
assigned to the user which could be Administrator, Oper-
ator, User or No Access.
6. Check the SNMP Status check box to enable SNMP
access for the user.
7. Choose the SNMP Access level option for user from the
SNMP Access dropdown list. Either it can be Read Only
or Read Write.
8. Choose the Authentication Protocol to use for SNMP
settings from the drop down list.
9. Choose the Encryption algorithm to use for SNMP set-
tings from the Privacy protocol dropdown list.
10.In the Email ID field, enter the email ID of the user. If the
user forgets the password, the new password will be
mailed to the configured email address.
 Email Format: Two types of formats are available:
 AMI-Format: The subject of this mail format is 'Alert
from (your Hostname)'. The mail content shows sensor
information, ex: Sensor type and Description.
 Fixed-Subject Format: This format displays the mes-
sage according to user's setting. You must set the sub-
ject and message for email alert.
11. In the New SSK Key field, click Browse and select the
SSH key file.
12.Click Add to save the new user and return to the users
list.
13.Click Cancel to cancel the modification and return to the
users list.
Modify an existing user:
Note:
 Password must be at least 8 characters long.
 White space is not allowed.
 This field will not allow more than 20 characters.
Note:
Password field is mandatory, if SNMP Status is enabled.
Note:
Password field is mandatory, if Authentication protocol is changed.
Note:
SMTP Server must be configured to send emails.
Note:
SSH key file should be of pub type.