780C Multi-Interface Interoperability Tester – User Guide Page 210
12.3 Procedures for using the Command Line Interface through RS-232 Port
(780C only)
Use the following procedures for command line control of the 780C via the RS-232 serial port.
Please note if you experience a different behavior on your PC, refer to the 780C release notes on the Quantum
Data website at: http://www.quantumdata.com/downloads/index.asp.
1. Power up the 780C and touch select Preferences from the 780C top level menu.
2. Select More to view the second Preferences page.
3. Choose the baud rate for the RS-232 port.
To Next Page
Loading...
