Quantum Data 780C - Procedures for Viewing Video on an SDI Source Device

780C Multi-Interface Interoperability Tester – User Guide Page 98
September 29, 2014
Revision A1
Table 6-2: Format Analyzer
Color space
Color space and sampling
Color space:
 YCbCr
 RGB
 xvColor
Sampling:
 4:4:4
 4:2:2
 4:2:0
Basic colorimetry
The ITU colorimetry standard.
Pixels repeated
Indicates whether pixel repetition is active.
Video ID code (VIC)
The CEA video identification code number.
Resolution
Shows the horizontal and vertical resolution as well as the frame rate and the aspect ratio.
AVmute status
The current setting of the AVmute parameter in the General Control Packet.
HDCP
Indicates the HDCP encryption status either: 1) Encrypted or 2) Unencrypted.
6.1.6 Procedures for Viewing Video on an SDI Source Device
Use the following procedures to test the video from an SDI source device. You can view the incoming video
and check the video and timing parameters of the incoming video.
1. Make the physical connection between the 780C SDI IN port and the source device under test using the
configuration instructions above.
2. Enable the SDI Input port.
3. Touch select Video Display from the Home menu shown below.