780C Multi-Interface Interoperability Tester – User Guide Page 15
 Configure the baud rate of the RS-232 interface
on the 780C (N/A to 780).
 Off – Keypad connected to RS-232 is disabled.
 On – Keypad connected to RS-232 is enabled.
 USB Storage Flash
 Application Flash
 FPGA Flash
 Calibrate the touch screen display
Viewing Source Data Island Packet
Testing Video from an HDMI Source Device
Viewing the Incoming 4K Video on a Connected Display using Passthrough
Viewing Source Data Island Packet
Testing HDCP Max Devices on an HDMI Source Device
Viewing the CEC devices on an HDMI network
Testing Audio of an HDMI Source Device
Procedures for Monitoring LPCM Audio from a Source Device (780C only)
Verifying the EDID on an HDMI HDTV or HDMI Repeater Device
Testing HDCP on an HDMI HDTV or HDMI Repeater Device
Viewing the CEC devices on an HDMI network
Procedures for Monitoring Auxiliary Channel events and transactions
Using the 780C Test Instrument to Test HDMI Cable or Repeaters
Procedures for Installer Utility
Using the 780C Test Instrument Installer Utility
Using the 780C Test Instrument Installer Utility
Using the 780C Test Instrument Installer Utility
3.3.2 Back Navigation
When you navigate away from the Home screen a white arrow will appear in the upper left next to the name of
the of the screen you are on. You can navigate to the previous screen by touch selecting this arrow. In the
example below, touch selecting the upper left area on or near the white, left facing arrow next to Signal Type
will take you to the previous screen.
To Next Page
Loading...
Need help?
General
