Remote control commands
R&S
®
NRPxxP
112User Manual 1179.5760.02 ─ 02
Example:
SYST:ERR:COUN?
Query
1
Response: One error has occurred since the error queue was
last read out.
Usage: Query only
SYSTem:ERRor[:NEXT]?
Queries the SCPI communication error queue for the oldest entry and removes it from
the queue.
Returns an error number and a short description of the error.
Example:
SYST:ERR?
Query
0, 'no error'
Response: No errors have occurred since the error queue was
last read out.
Usage: Query only
SYSTem:FWUPdate <fwudata>
Loads new operating firmware into the power sensor. Rohde & Schwarz provides the
update file. For further details, see Chapter 6, "Firmware update", on page 28.
If you want to integrate a firmware update function in an application, see the example
given in Chapter 6.2.2, "Using remote control", on page 30.
Setting parameters:
<fwudata> <block_data>
Definite length arbitrary block data containing the direct copy of
the binary *.rsu file in the following format:
#
Single digit indicating how many digits follow to specify the size
of the binary file.
Number that specifies the size of the binary file.
Binary data
0x0a as appended delimiter for line feed
Usage: Setting only
SYSTem:FWUPdate:STATus?
Reads the result of the firmware update performed using SYSTem:FWUPdate
on page 112.
While a firmware update is in progress, the LED of the power sensor flashes in bright
white color. When the firmware update is completed, you can read the result.
The result of the query is a readable string.
Configuring the system
To Next Page
Loading...
Need help?
General
