R&S NRP P Series User Manual

Remote control commands
R&S
®
NRPxxP
50User Manual 1179.5760.02 ─ 02
8.5.5 Configuring the trigger
Further information:
●
Chapter 8.5, "Controlling the measurement", on page 41
Remote commands:
TRIGger:ATRigger:DELay.................................................................................................50
TRIGger:ATRigger:EXECuted?..........................................................................................50
TRIGger:ATRigger[:STATe]................................................................................................50
TRIGger:COUNt.............................................................................................................. 51
TRIGger:DELay............................................................................................................... 51
TRIGger:DTIMe............................................................................................................... 51
TRIGger:EXTernal<2...2>:IMPedance................................................................................ 52
TRIGger:HOLDoff............................................................................................................ 52
TRIGger:HYSTeresis........................................................................................................52
TRIGger:IMMediate..........................................................................................................52
TRIGger:LEVel................................................................................................................ 53
TRIGger:LEVel:UNIT........................................................................................................53
TRIGger:SENDer:PORT................................................................................................... 53
TRIGger:SENDer:STATe...................................................................................................54
TRIGger:SLOPe.............................................................................................................. 54
TRIGger:SOURce............................................................................................................ 54
TRIGger:SYNC:STATe......................................................................................................55
TRIGger:ATRigger:DELay <delay>
Effective only if TRIGger:ATRigger[:STATe] is set to ON.
Sets the delay between the artificial trigger event and the beginning of the actual mea-
surement
Parameters:
<delay> Range: 0.1 to 5.0
*RST: 0.3
Default unit: Seconds
TRIGger:ATRigger:EXECuted?
Queries the number of measurements that were triggered automatically since
TRIGger:ATRigger[:STATe] was set to ON.
In normal scalar measurements, this number can only be 0 or 1. If a buffered measure-
ment was executed, this number indicates how many results in the returned array of
measurement data were executed without a real trigger event.
Usage:
Query only
TRIGger:ATRigger[:STATe] <state>
Controls the automatic trigger function. If enabled, an artificial trigger is generated if the
delay time has elapsed after the measurement start and no trigger event has occurred.
Controlling the measurement

R&S NRP P Series Specifications

General

Brand	R&S
Model	NRP P Series
Category	Accessories
Language	English