Preparing for use
R&S
®
NRPxxP
17User Manual 1179.5760.02 ─ 02
5. Connect the delivered external power supply unit to the R&S NRP‑Z5 and to an AC
supply connector.
6. Connect the trigger input of the R&S NRP‑Z5 with a BNC cable to the trigger
source (optional).
7. Connect the trigger output of the R&S NRP‑Z5 with a BNC cable to the trigger
device (optional).
8. On the computer, start a software application to view the measurement results.
See Chapter 5, "Operating concepts", on page 20.
3.7.2 Base unit
As a controlling host, you can use an R&S NRX base unit.
You can also operate the power sensor using other supported Rohde & Schwarz
instruments with a sensor connector. For details, see also the user manual of the
instrument.
► Establish the connection with the base unit using:
Host interface, see Chapter 5.5, "R&S NRX", on page 26.
Connecting to a controlling host
To Next Page
Loading...
