R&S NRP P Series User Manual

Preparing for use
R&S
®
NRPxxP
14User Manual 1179.5760.02 ─ 02
2. Tighten the union nut manually.
To disconnect the host interface of the power sensor
1. Loosen the union nut of the screw-lock cable connector.
2. Remove the cable.
3.7 Connecting to a controlling host
As a controlling host, you can use:
●
Computer
●
Base unit
For operating the power sensor, you can choose from various possibilities. For details,
see Chapter 5, "Operating concepts", on page 20.
3.7.1 Computer
If the controlling host is a computer, you can operate the power sensor in several ways.
For details, see Chapter 5, "Operating concepts", on page 20.
► Establish the connection using:
● Host interface
See Chapter 3.7.1.1, "Simple USB connection", on page 14.
See Chapter 3.7.1.2, "R&S NRP‑Z5 sensor hub setup", on page 15.
3.7.1.1 Simple USB connection
All R&S NRPxxP power sensors can be connected to the USB interface of a computer.
Sleep mode
If a power sensor is connected to a laptop and you close the laptop, the power sensor
goes automatically into sleep mode to minimize its power consumption.
If you open the laptop again, the power sensor wakes up and enumerates in the host
system again. The power sensor does not recall the settings before the sleep mode
and starts afresh, as after booting or rebooting.
Required equipment
●
R&S NRPxxP power sensor
●
R&S NRP‑ZKU cable
Connecting to a controlling host

R&S NRP P Series Specifications

General

Brand	R&S
Model	NRP P Series
Category	Accessories
Language	English