Remote control commands
R&S
®
NRPxxP
84User Manual 1179.5760.02 ─ 02
User interface of the S-Parameters program
Figure 8-10: S-Parameters dialog
Menu bar.......................................................................................................................84
└ File.................................................................................................................. 84
└ Sensor.............................................................................................................85
└ Device.............................................................................................................85
└ Options............................................................................................................85
└ User Data..............................................................................................85
└ Remote................................................................................................. 85
└ Show Cal. Data.....................................................................................85
Global Flags..................................................................................................................86
└ S-Parameter Correction ON by Default.......................................................... 86
└ S-Parameter Correction State Locked............................................................86
└ S-Parameter Device Locked...........................................................................86
└ Use Flags in Factory Cal. Data Set.................................................................87
Device table.................................................................................................................. 87
Menu bar
Contains the following submenus.
File ← Menu bar
Provides options for loading and saving calibration data files, see:
●
"To change the S-parameter data" on page 89
●
"To load an uncertainty parameter file" on page 90
Configuring basic measurement parameters
To Next Page
Loading...
