R&S NRP P Series - General Status Register Commands; Reading the Condition Part; Reading the Event Part

Remote control commands
R&S
®
NRPxxP
118User Manual 1179.5760.02 ─ 02
8.13.1 General status register commands
STATus:PRESet.............................................................................................................118
STATus:QUEue[:NEXT]?.................................................................................................118
STATus:PRESet
Resets the edge detectors and ENABle parts of all registers to a defined value.
Usage: Event
STATus:QUEue[:NEXT]?
Queries the most recent error queue entry and deletes it.
Positive error numbers indicate power sensor-specific errors. Negative error numbers
are error messages defined by SCPI.
If the error queue is empty, the error number 0, "No error", is returned.
Usage:
Query only
8.13.2 Reading the CONDition part
STATus:DEVice:CONDition?
STATus:OPERation:CALibrating:CONDition?
STATus:OPERation:CONDition?
STATus:OPERation:MEASuring:CONDition?
STATus:OPERation:SENSe:CONDition?
STATus:OPERation:TRIGger:CONDition?
STATus:QUEStionable:CALibration:CONDition?
STATus:QUEStionable:CONDition?
STATus:QUEStionable:POWer:CONDition?
Usage:
Query only
8.13.3 Reading the EVENt part
STATus:DEVice[:EVENt]?
STATus:OPERation:CALibrating[:SUMMary][:EVENt]?
STATus:OPERation[:EVENt]?
STATus:OPERation:MEASuring[:SUMMary][:EVENt]?
STATus:OPERation:SENSe[:SUMMary][:EVENt]?
STATus:OPERation:TRIGger[:SUMMary][:EVENt]?
STATus:QUEStionable:CALibration[:SUMMary][:EVENt]?
STATus:QUEStionable[:EVENt]?
STATus:QUEStionable:POWer[:SUMMary][:EVENt]?
Usage:
Query only
Using the status register