Raymarine C140w - Using Buttons and Softkeys; Using the Cursor

3.4Usingbuttonsandsoftkeys
Thefollowingdiagramshowsyouhowtoselectfunctionsusingthe
buttonsandsoftkeys:
WAYPOINT AT
CURSOR
WAYPOINT AT
VESSEL
WAYPOINT AT
LAT/LONG...
GO TO WAYPOINT
OPTIONS…
REVIEW AND EDIT
WAYPOINTS
ERASE WAYPOINT SORT LIST
SET DEFAULT SYM
& GROUP...
WAYPOINT
GROUPS...
VIEW AND EDIT
DETAILS…
EDIT DEFAULT
SET UP DEFAULT
SYMB GROUP
D11529-1
Example:
The example above shows the series of button and softkey presses
required to change the waypoint default symbol or group.
Access system functions or change what you see on-screen.
Within the text of this document they are written in bold capitals
e.g. WPTS/MOB.
Press and hold to access short cuts.
They change depending on
application or function
being performed.
Press the corresponding key
(below the screen) to select.
Further softkeys may be
displayed.
If a key has several options,
each press will highlight the
next option.
If a key displays a single
value or a slider above, use
the rotary control to adjust.
Within the text of this
document they are written
in capitals e.g. SORT LIST.
Buttons
Softkeys
PAGE
ACTIVE DATA
WPTS
MOB
Note:T odisabletheaudible"beep"thatyouhearwhenabutton
orsoftkeyispressed,gotoMenu>DisplaySetup>KeyBeep.
3.5Usingthecursor
IntheChartandRadarapplications,thecursorisusedtomove
aroundthescreen:
D7366_3
Thecursorappearsonthescreenasawhitecross.
D7368_2
Ifthecursorhasnotbeenmovedforashortperiodoftime,
itchangestoacirclewithacrossinit,tomakeiteasierto
locateonthescreen.
D7369-2
WPT
Thecursoriscontext-sensitive-whenitisplacedoveran
objecte.g.awaypointorchartfeature,itchangescoloranda
labelorinformationassociatedwiththeobjectisdisplayed.
Whenyouplacethecursorovercertainitems,thesoftkeys
changetoenableyoutoaccessrelatedoperations.
Listofcursorlabels
LabelFeatureApplication
A/B
Rulerline
Chart
AISAIStargetChart
COGCourseOverGround
vector
Chart
CTRCenterofradar
Radar
20C-SeriesWidescreenuserreference