Reely HT-6 - Receiver voltage RX battery“

28
Receiver voltage „RX battery“
Depending on the receiver voltage supply used, this menu can be used to set the voltage values where the remote
control visually and acoustically displays threatening deep discharge.
To set the receiver voltages, proceed as follows:
• Callthe„RXSetup“menu.
• Usethebuttons„UP“or„DOWN“toselectthemenuitem„RX
Battery“ and activate it with the button „OK“.
• Usethebuttons„UP“and„DOWN“tosetthelowestvoltage
value „Low“ that is already selected with the cursor arrow. If
the button „OK“ is pushed and held, the factory parameters
are called.
• Brieypushthebutton„OK“toswitchtothenext-highervolta-
ge value „Alarm“. The setting is made with buttons „UP“ and
„DOWN“ again.
• Usethebutton„OK“toswitchtothevoltagevalueatfullychar-
ged rechargeable battery „High“ and again set the required
value with the buttons „UP“ or „DOWN“.
• Keepthebutton„CANCEL“pushedforalongerperiodtosave
the set voltage values. The display then shows the system
setup menu again.
• Pushthebutton „CANCEL“repeatedlyuntilyou getbackto
the operating display.
Since the adjustable voltage values depend on each
other, it may be required to increase the voltage value
forafullychargedrechargeablebatteryrst,tothen
be able to enter higher alarm values as well.
If the set thresholds are undercut, the battery icon for
thereceiverbatterywillashatoperationoftheremo-
te control and the remote control transmitter will make
warning or alarm sounds.
Figure 23