Reely HT-6 - Intended Use; Product Description

5
3. Intended Use
The6-channelremote control„HT-6“issolely designedforprivate useinthe eldofmodel construction andthe
operating times associated with it. This system is not suitable for industrial use, such as controlling machines or
equipment.
Any use other than that described above can damage the product and involves additional risks such as short circuit,
re,electricshock,etc.Theproductmustnotbetechnicallychangedorconverted!Thesafetyinformationmustbe
observed at all times!
Observe all safety information in these operating instructions. They contain important information on hand-
ling of the product.
You are solely responsible for the safe operation of your remote control and your model!
4. Product Description
The „HT-6“ remote control system is a radio remote control system ideally suited for model planes or helicopters.
The 6 proportional channels allow you to use the steering function and control function independently from each other.
The remote control also features several mixing and memory functions needed for the different models. The settings
of up to 20 different models can be saved in the remote control system.
Inadditiontheremotecontrolunit offerstheoption ofcalling differentightmodesand thussetindividualrudder
deectionsforspecicightphasessuchastake-offorlanding.
Thanks to pioneering 2.4 GHz radio transmission with return channel, you can read current values, such as the recei-
ver voltage or the quality of the radio control, comfortably at the display of your remote control transmitter. In connec-
tion with a receiver with I-BUS system and the corresponding sensor modules (each not enclosed), further measured
values such as temperature, rotating speed or speed can be recorded and transmitted to the transmitter.
The LC display is easily readable and the easy-to-use buttons permit simple, quick and safe data input. Thanks to
electronic trimming, the rudders are always in the correct position. The last set position is assumed automatically
when the remote control is switched on!
The ergonomic casing can be held and operated comfortably and allows you to safely control the model.
The 2.4 GHz-receiver warrants best reception for secure signal transmission.
For operation, 4 AA/mignon batteries (e.g. Conrad item no.: 652507, pack of 4, order 1x) are required for the trans-
mitter.WherenoightcontrollerwithBECswitchisused,youalsoneed4AA/mignonbatteriesforthereceiver(e.g.
Conrad item no. 652507, order once) or 4 AA/mignon rechargeable batteries with the corresponding battery holder.
Alternatively, 4- or 5-cell NiMH receiver batteries can also be used with the switch cable.