Reely HT-6 - Remote Control Operation

64
15. Remote Control Operation
Thebestremotecontrolisoflittleuseifthebatteriesusedareatandtherechargeablebatterieshavenotbeen
charged. Thus, you should Check the transmitter batteries (battery tester) and charge the receiver batteries to the
manufacturer‘sspecicationsbeforeeveryday‘sying.Itisimportantthatyoudon‘tjustquicklychargethebatteriesa
little. Use suitable devices with a discharge function so that you have an exact overview of the current power capacity
of your rechargeable batteries.
Beforeyouoperateyourmodelintheyingarea,rstcheckthecorrectsettingoftheremotecontrol.Itisparticularly
important to ensure the correct model memory is activated and that the trim buttons are set to the respective centre
settings. Also be sure to test the correct setting of all switches and dials.
Switch on the receiver system in the model and check all control functions at the model then. Only perform a range
testwiththeenginerunningbeforetherstight.Forthis,ahelperhastoholdthemodelabout1mabovetheground.
At a direct line of sight, the model must react without defects to the control signals even from a distance of at least
400 m.
Once you have checked your range and all functions are working without defects, you can start your model. If your
modeldoesnotystraight,youhavetheoptionoftrimmingtheruddersinight.Sinceyoushouldalwayshavesight
contacttothemodelduringight,changestothetrimmingareindicatedbyasound.Theremotecontrolemitsashort
signal sound for each press of a trim stick. The tone height depends on the trimming direction. The middle position is
acoustically indicated by a longer signal.
Afterlanding,switchoffthereceiverrstandthenthetransmitter.
Attention!
Never turn the transmitter off when the model is still in operation. Signal interference can cause the model
to carry out uncontrolled and unexpected servo movements or electric motor(s) may unexpectedly start to
run at full power.
Then set the linkage rods on your model so that the trimming symbol in the display can be returned to the middle
positionandthemodelnonethelesscontinuestoyinastraightline.Inthecaseofminimaldeviationsyouhavethe
option of slightly adjusting the sub-trimming.