Reely HT-6 - Throttle Switch Throttle Hold“

63
o) Throttle Switch „Throttle Hold“
In order to be able to practice an autorotation landing, you need to uncouple the motor function from the pitch stick
usingatoggleswitch.Thecombustionenginemustbeatsufcientthrottlesothatthecentrifugalclutchisreliably
open. Nevertheless, the motor should be set so that it spontaneously takes in gas and can be restarted immediately
if the situation so requires.
The function can also be used as a safety switch. If the model is carried to the starting point after starting up the
combustion engine, the throttle switch can be activated. Accidental adjustment of the throttle control stick then will not
lead to undesired revving up of the engine.
Setting the throttle switch:
• Switchonthetransmitterandcallthefunctionsettingmenu.
• Movethecursorarrowtothemenuitem„Throttlehold“with
the two buttons „UP“ and „DOWN“.
• Brieypushthebutton„OK“toactivatethemenuitem.
The display shows the current switching condition of the
throttle switch and the set value. The respective setting of the
toggle switch for the throttle switch is also displayed at the
lower edge of the display. The display „Not engaged“ shows
that the throttle switch is deactivated. „Engaged“ means that
the throttle switch is activated.
• Pushing the buttons „UP“ or „DOWN“ can activate „On“ or
deactivate „Off“ the throttle switching.
• Whenpushingthebutton„OK“,thecursorarrowwilljumpto
the setting value for throttle switching.
• Pushing the buttons „UP“ or „DOWN“ permits setting the
throttle servo with activated throttle switching so that the motor
will securely run through in idle operation. If the button „OK“ is
pushed and held, the factory parameters are called.
• Keepthebutton„CANCEL“pushedforalongerperiodtosave
the settings. The display then shows the function setup menu
again.
• Whenpushingthetoggleswitchforthrottleswitching,themo-
tor has to switch between the set idle speed and the speed
corresponding to the current position of the control stick for the
throttle function.
• Pushthebutton „CANCEL“repeatedlyuntilyou getbackto
the operating display.
Figure 54