Reely HT-6 - Page 50

50
 Ondemand,anothertoggleswitchforswitchingtheightconditionscanbeassignedinthefollowingmenu
switch assignment menu (Switches assign).
 Intheightcondition„Idleup“,thepitchcurveshouldbesetsothattherotorbladesreachthemaximumpositive
and negative angle of attack.
• Repeattheaboveprocessagainandsetthedesiredvalueofthepitchcurveforallvepointsintheightcondition
„Idle up“ as well.
• Keepthebutton„CANCEL“pushedforalongerperiodtosavethesettings.Thedisplaythenshowsthefunction
setup menu again.
• Pushthebutton„CANCEL“repeatedlyuntilyougetbacktotheoperatingdisplay.
Attention!
 Preciseinformationontherespectiveanglesofattachoftherotorbladesinthedifferentightconditionscan
usually be taken from the documents of the model helicopter.
Important:
 Pleaseobservethatthepitchandthrottlecurvesinuenceeachother.Ifyouliftthepitchcurveinaspecic
point, the larger angle of attack of the rotor blades may require lifting the throttle curve in this point as well.